botoutongyong@163.com

+86 155 3288 3866

News

Home > News > News

Precautions When Installing the Metal Compensator

Sep. 14, 2021

As a metal compensator supplier, I will introduce you.


Metal compensator is widely used in the steel industry. In large-scale blast furnaces and hot blast stoves, large-diameter metal compensator expansion joints are mainly used. For example, in the blast furnace roof equipment, the pressure supply and discharge pipeline system, the cooling pipeline system of the blast furnace body, the air supply pipeline, the oxygen supply pipeline and the cooling water pipeline of the large converter roof, etc., all use different types of metal compensation Expansion joint. A universal compensator expansion joint is installed in the air supply branch pipe of the blast furnace body, which can not only compensate the displacement of the pipeline, but also reduce the installation stress.

 

Axial Internal Pressure Type Ripple Compensator

Axial Internal Pressure Type Ripple Compensator


What Are the Precautions When Installing the Metal Compensator?

Below, I will introduce you in detail:

 

1. The two interfaces or flange lines should be kept on the same axis, and the coaxiality error should be ±5mm. When the amount of lateral compensation is too large, the compensator should be pre-displaced according to the requirements of the construction drawings.

 

2. The torsion angle deviation is not more than 2.5'.

 

3. The installation length deviation of the compensator is ±5mm.

 

4. It is not allowed to use the deformation of the metal compensator (including compression, stretching, torsion, etc.) to forcibly adjust the installation error of the piping system during installation.

 

5. To prevent the impact of heavy objects or sharp angles of metal from piercing the telescopic body (metal bellows) of the metal compensator, the metal telescopic body should be protected for on-site installation and construction to prevent welding spatter from damaging the telescopic body (metal bellows).

 

6. It is not allowed to strike arc or knock on the metal compensator.

 

7. When installing, make the flow direction mark on the metal compensator consistent with the flow direction of the medium in the pipeline.

 

8. It is forbidden to use transportation tie rods and tie rods as lifting load-bearing parts.

 

9. The lifting of a metal compensator with a cross-sectional area of more than 1M should be uniformly stressed, otherwise uneven force will cause serious deformation and warpage of the metal compensator, affecting installation and damaging internal structural parts.

 

10. After the compensator is installed, remove the transportation fixing screw, limit plate and pipeline internal substance with yellow marks.

 

11. In order to prevent excessive dust accumulation in the corrugation from affecting the service life, the dust discharge port at the lower end should be opened every three months to discharge the dust.

 

Botou Tong Yong Bellows Manufacturing Co., Ltd. has been committed to metal corrugated compensators, non-metallic compensators, expansion joints, pipeline expansion joints, Ventilation butterfly valve, Metal hose, Star type unloader, Rubber joint, Sleeve compensator, Pipeline Filter, valves and pipe fittings and other products Development and production.

If you want to learn more about our products, please contact us.


  • wechat
Chat with Us